Customer Service M-F 7am-5pm
1-888-633-0283
Our customer service representatives are ready to take your orders today.

Hyster

In order to help prevent the need for expensive lift truck repairs, it is recommended to inspect the front end of your lift truck regularly as part of your daily and even pre-shift inspection. By catching any problems in advance or as they happen, you can also help avoid damage to any cargo as well. The following includes some of the general guidelines on what specific stuff to check during frequent inspections of your material handling fleet.

Forks
It is essential to frequently inspect the forks because if they are cracked or worn out, they could probably fail without warning. Any kind of fork damage means that your forklift must instantly be removed from service until it is safe and repaired once more. Visually check your forks for any noticeable indications of wear or damage. If the cracks run deeper than on the surface, replace them. Any wear on the forks beyond 10 percent is another indication that you must replace the forks.

Mast
The mast should ideally tilt forward and backward while being able to move up and down. You may need to grease the mast strip sliding surfaces and fittings if you find that the sliding surfaces are binding. On the inner mast there is a fitting situated on each side. The lift bracket side rollers are another lubrication point and there is also one on each side roller. Once the lubricating has been done, raise and lower the mast and also tilt it backward and forward a few times in order to make sure that the lubricant is worked into the fittings properly.

Tilt Cylinders
Uncontrolled mast movement can be a result of oil leakage; hence, your inspection should include checking for oil leaks and for damage. Whether the leaks are located inside of the cylinder or are external, the end result may be loss of fluid and cylinder drift. If there are any signs of leaks or damage, you may have to replace the whole cylinder assembly, or just the seals.

Chains
The mast chains have to be inspected to see if they are being stretched beyond their acceptable limits. Also, check the chain wear guage or check the chains for indications of damage. If wear is present beyond 2 percent, replace the chain. Also replace it if the chain appears kinked or rusted. The sheave bearings and the chain rollers also need to be checked for indications of wear.

The mast lift chain will usually wear at the pin-to-link connections. You could experience chain failure if you notice wear. This can end up damaging front end parts or even the product. If you require help determining what precisely to check on your forklifts or if you do not have time on hand to perform frequent fleet inspections, just call your local forklift dealer. Their skilled service technicians will help your perform PM or planned maintenance checks based on your application needs and scheduling.

Click to Download the pdf



Forklift Mast Articles

  • Nissan
    Propane Forklifts One inconvenience of propane tanks is to have to change, however there is little risk to running out of fuel on a propane lift truck. These units tend to be cheaper to use than the electric and diesel unit forklift. The debate ...
    More
  • Yale
    IC Lift Trucks The IC forklift belongs within the class V and IV forklift classification. They can be diesel, liquid propane or gas units. Primarily, the ICE or also referred to as internal combustion engine models are used outside, since they ...
    More
  • Clark
    The forklift is a material handling equipment utilized to lift and transport loads from one place to another. Each part of a forklift has a particular function. Various components could be utilized to move the load either vertically or ...
    More
  • Komatsu
    Forklift Basics A forklift is a versatile equipment. It is a small vehicle that has attachments on the front which enable it to lift and move a variety of loads. Forklifts are common features in warehouses and factories. The driver of a forklift ...
    More
  • Doosan
    Basic Training Information for Liquid Petroleum Gas LPG or liquefied petroleum gas is a fuel which has 90 percent propane and has no smell or color. It is derived from natural gas. Liquid Petroleum Gas is extracted using a method called ...
    More
  • Toyota
    Motorized Pallet Truck The Walkie-Rider, Walkie or Rider is a Motorized Pallet Truck which is basically a motorized version of a pallet jack. They come in both "Walkie" models and "Rider" versions. Like what the name implies, the walkie model ...
    More
  • Crown
    Very Narrow-Aisle Turret Trucks Crown has developed an innovate line of heavy-duty turret trucks in the industry. The company has established a new level of standard. Crown has developed the fastest travel speeds as well as the fastest lift ...
    More

Lift Parts Express

Our professional team is ready to provide you with all the support you need. Great prices and fast delivery times is what you will come to expect from us. Call us today at:

TOLL FREE: 1-888-633-0283


www.mastchain.com

Email Us



Lift Parts Express prides itself on the diversity and volume of parts we carry. Regardless of the model of lift truck you run, we have the parts you need. The cost savings we can offer will...   About Us